Required Tools and Supplies
- Eye Protection
- Nitrile Gloves
- Shop Rags
To learn more about tools, read the Tools and Fasteners Guide. Always wear safety glasses and nitrile gloves when servicing your Polaris RANGER.
To inspect and replace the air filter on your RANGER XP 1000, follow these steps:
1. Park the vehicle on a flat, level surface, ensure it is in PARK and remove the key.
2. Tilt the rear cargo box to access the airbox.
3. Wipe the area around the airbox.
4. Release the five airbox cover latches and lift the cover up and out to remove the cover.
5. Remove the air filter and inspect it for excessive debris or damage and replace, if necessary. A new air filter is part number 7082265.
6. Inspect the airbox for oil or water deposits and wipe away any deposits with a clean shop rag. Caution: If the filter has been soaked with fuel or oil, it must be replaced. Do not attempt to clean the air filter.
7. Clean the airbox cover.
8. Place the air filter into the airbox and reposition the lower airbox cover and install the five retaining latches. Note: Make sure the hinge pins are properly seated and cover is properly aligned when reassembling the airbox.
9. Lower the cargo bed.
For more information, see your authorized Polaris Dealer. To find a dealer near you, use the Dealer Locator.
Maintenance tips, procedures and specifications can be found in your Owner’s Manual.
To find diagrams and replacement part numbers, use the online parts catalog.
Unless noted, trademarks are the property of Polaris Industries Inc.
© 2024 Polaris Industries Inc.
