Skip to content Skip to navigation Skip to footer

2016-2022 Pro-RMK AXYS Drive Belt Inspection and Replacement

Always wear safety glasses and nitrile gloves when servicing your snowmobile.

To remove, inspect and replace the drive belt on a Polaris Pro-RMK AXYS snowmobile, follow these steps.

Caution: Do not attempt to remove the drive belt after operating in reverse. The snowmobile must be stopped after forward motion to prevent damage to components during belt removal.

1. Ensure the vehicle is on a flat, level surface.

2. Remove the left side panel by releasing the rubber strap and turning the two quarter-turn latches. Pull the side panel out and lift up to remove.

3. If needed, rotate the driven clutch counterclockwise 1/4 of a turn by hand to disengage reverse.

4. Set the parking brake.

5. Take note of the drive belt direction of rotation. The belt must be installed in the same direction if reusing.

6. Remove the clutch spreader tool from the side panel trim and spread the trim as needed to access the clutch.

7. Insert the clutch spreader tool into the threaded hole of the driven clutch and turn it clockwise to spread the clutch. Notice: If the tool does not turn readily, rotate the driven clutch an additional 1/4 of a turn counterclockwise and try again.

8. Carefully walk the belt off the driven clutch and remove it from the drive clutch.

9. Inspect the belt for any fraying, hour-glassing, loose cords, missing cogs, abrasions, burns or damage. Replace if needed. The belt is part number 3211183part number 3211115, or part number 3211216, depending on your vehicle. Use the online part fitment tool to determine the required belt for your vehicle. 

10. Clean the area around the clutches thoroughly. Warning: Failure to remove ALL debris when replacing the belt could result in vehicle damage, loss of control and severe injury or death.

11. If replacing the belt, clean it with a mixture of warm soapy water and ensure the part number on the belt is facing outward when installed.

12. Loop the belt over the drive clutch and begin to walk it over the driven clutch sheave.

13. Spin the belt while removing the clutch spreader tool to help seat the belt.

14. Completely remove the clutch spreader tool.

15. Reconnect the side panel trim and reinstall the clutch spreader tool.

16. Reinstall the side panel by inserting the tabs at the bottom and top. Secure the rubber strap and turn the two quarter-turn latches.

For more information, see your authorized Polaris Dealer. Find a dealer near you with the Dealer Locator.
Maintenance tips, procedures and specifications can be found in your Owner's Manual.
To find diagrams and replacement part numbers, use the online parts catalog.

YouTube® is a registered trademark of Google LLC

Unless noted, trademarks are the property of Polaris Industries Inc.
© 2022 Polaris Industries Inc.

Keyword(s) video , belt , maintenance , inspect , replace , change , changing ,