Skip to content Skip to navigation Skip to footer

Extreme Front Bumper Installation

The following video demonstrates how to install an Extreme Front Bumper (part number 2878688) to your Polaris snowmobile.

To install the bumper you need a 3/16-inch drill bit, ratchet wrench, T40 TORX® bit, torque wrench, 10mm socket, 10mm wrench and spring puller. To learn more about tools, read the Tools and Fasteners Guide

The video includes removing the side panels and hood (0:50), removing the spare belt holder (1:20), disconnecting the exhaust temperature sensor (1:33), removing the exhaust system (1:53), removing the existing bumper (4:12), drilling a hole for the bumper mount (6:32), installing the new bumper (7:11), reinstalling the exhaust system (9:40), reconnecting sensors (12:46), reinstalling the spare belt holder (14:00) and reinstalling the hood and side panels (14:12).

The Extreme Front bumper comes in three varieties: aluminum (part number 2878688), white aluminum (part number 2878688-133) and black aluminum (part number 2878688-458). 

View the instructions for this kit by searching the Polaris Accessory Installation Instruction Site.

For more information, see your authorized Polaris Dealer. Find a dealer near you through the Dealer Locator.
Maintenance tips, procedures and specifications can be found in your Owner's Manual.
View the full selection of bumpers for your snowmobile under the Accessories section.

TORX® is a registered trademark of Acument Intellectual Properties, LLC
YouTube® is a registered trademark of Google LLC

Unless noted, trademarks are the property of Polaris Industries Inc.
© 2022 Polaris Industries Inc.